Aubrey Roofers Who Install Roofs That Last
Get a Free Estimate
Trusted Suppliers
Why New Roofs Fail Early in Aubrey, TX
Materials rarely fail young. Installation does. The faults that end a roof in its first few years are all small decisions made during a single day of work, and every one of them is invisible from the ground once the last shingle is down.
Overdriven and Underdriven Nails
A roofing nail should sit flat and flush, with the head just touching the shingle. Driven too hard it cuts through the mat, and the shingle now hangs on a slot instead of a fastener. Left standing proud it holds the course above off the deck and wears a hole through it. Both faults come from air pressure nobody checked, and both surface as leaks within a couple of seasons.
Nails Placed Above the Nail Line
Every shingle has a marked zone where its nails belong. Fasteners set in that zone pass through two layers and hold the course below as well. Set them an inch high and they catch one layer only, so the shingle underneath is held by adhesive alone. The roof looks finished and performs as though half its fasteners are missing. The first real wind finds out.
Recording Installation Defects on an Aubrey Roof
When we inspect a young roof in Aubrey we photograph the nail heads, lift shingles to show placement against the nail line, open the eave to show whether a starter course exists, and record the valley and flashing detail. Everything is dated and written into a scope. The file is yours. Any claim or warranty discussion that follows stays between you and the other party.
Starter Course, Valleys and Reused Flashing
A missing starter course leaves the first row of shingles with nothing sealed under its joints, so water runs straight to the deck at the eave. Valleys cut or woven the wrong way funnel water into a seam never built to carry it. Flashing pulled off an old roof and refitted is bent metal with old nail holes in it. All three save an hour and cost a roof.